The G-Link™ G-Bus Expansion Series makes it easy and affordable to monitor a wider range of site equipment with the GSC3000, turning broadcast facility control into total site management. By utilizing the modular design of the GSC3000, G-Link products provide a direct link between the broadcast facility control system and the monitored site equipment. G-Link products eliminate the external wiring interfaces and relays normally required for equipment integration, saving rack space, time and money. Each of the G-Link products connects to the GSC3000 using the G-Bus and can be installed up to 1000 feet away. G-Link units operate like an I/O unit and are accessible through Lynx, the Voice Interface, and Web Interface. With its ease of use and convenience, the G-Link G-Bus Expansion Series takes flexibility and expandability to new levels.

Quick Jump... OneConnect AC-4/AC-8 Remote Outlet Controller GT-4 Remote Temperature Monitor GX-128 Interface for X10 Automation

---

OneConnect™

The OneConect™ provides a direct link between transmitters and other plant equipment and the GSC3000 broadcast facility control system. OneConnect eliminates the hardware needed for traditional wiring interfaces, and saves time spent wiring and documenting discrete remote control channels. Control your OneConnect as you would an I/O using Lynx, Web Interface, or Voice Interface.

Available Models:
OneConnect for Nautel V5/V10 transmitters
OneConnect for Acryodyne Quantum transmitters

---

AC-8 & AC-4 Remote Outlet Controllers

 

The AC-8 and AC-4 Remote Outlet Controllers allow broadcasters to combine device management and broadcast facility control using the same hardware and software platforms. By providing users with discrete control of 120VAC circuits, the AC-8 and AC-4 make it easy to power on and power off equipment at a remote location.

Just like a power strip but with a link to the GSC3000, the AC-8 and AC-4 allow broadcasters to use the GSC3000 for managing any device that would plug in to a normal wall outlet. Users can control power to PCs and other IT infrastructure. Heating and air conditioning units can also integrate, allowing temperature (and energy) control while away from the building. For equipment needing the occasional "power cycle" to solve a problem, the AC-8 and AC-4 can save wasted drive time.

The AC-8 is equipped with eight outlets, local push-button control, and takes a single rack unit. The AC-4 is built with mounting holes and equipped with four outlets.

 

---

GT-4 Remote Temperature Monitor

The GT-4 provides a practical way to situate temperature sensors in locations up to 1000 feet from the GSC3000. It allows broadcasters to monitor temperature conditions at critical areas of the facility that are not co-located with the GSC3000.

The GT-4 works with existing Burk Technology temperature sensors, models BTO, BTI, BTS, and an outdoor/general purpose sensor is included.

 

---

GX-128 Interface for X10 Automation

The GX-128 allows off-the-shelf X10 automation modules to integrate with the GSC3000, providing a way to control lights and non-critical appliances with minimal wiring and configuration requirements. By providing a convenient bridge between transmission equipment and consumer-grade lights and appliances, the GX-128 allows a broader range of remote control capability. Up to 128 individual X10 modules can be controlled with the GX-128. Includes one interface and one appliance module.